L’esthétique rencontre la fonctionnalité – achète maintenant les biberons au design protégé de LIINI®.
Parfaitement adapté aux besoins alimentaires de ton bébé
LIINI® a développé le premier biberon double verre au monde!
Le design protégé convainc par son aspect intemporel – sans aucun éléphant rose ou super-héros bleu – à l’extérieur pour maman & papa.
Une vie saine commence dès la première tétée de ton bébé. Lors de l’utilisation de biberons en plastique, des microparticules de plastique peuvent se détacher et pénétrer dans l’organisme de ton enfant.
En tant que parents, nous plaçons la santé de nos enfants au premier plan! C’est pourquoi nos biberons sont fabriqués à 100 % en verre borosilicaté – sans microplastique – à l’intérieur pour ton bébé.
Nos tétines sont conçues pour ressembler au sein de maman. Nous sommes tellement convaincus de nos biberons que nous te donnons une garantie d’acceptation. Cela signifie que soit ton bébé accepte le biberon, soit tu es remboursé.
Grâce au double vitrage, le lait reste plus longtemps prêt à boire pour ton bébé . Le verre extérieur protège en outre des brûlures en cas de contact inconscient avec ton bébé.
Les biberons sont tous 100 % compatibles avec nos chauffe-biberons.
Le meilleur: Grâce à l’isolation de la zone liquide , le réchauffement est plus rapide.
GTCs incl. Cancellation policy
© 2024 | LIINI GmbH
All rights reserved
Do you already have another ring at home?
If you already have a good fitting ring, you can use that to determine the size.
Step 1: Prepare material
Step 2: Measure the existing ring
Lay the existing ring flat on a flat surface. Make sure that it does not deform or twist. Use the ruler or tape measure to measure the inside diameter of the ring. This is the distance from one inner edge to the opposite inner edge of the ring. Note the measurement in millimeters.
Step 3: Compare with our size chart
Now compare the measurement you noted with our size scale and choose the appropriate ring size.
If you don’t have a matching ring at home, you can easily determine your size with the following procedure.
Step 1: Prepare material
Step 2: Measure the circumference of the finger
Wrap the thin strip of paper or string around the finger you want to wear the ring on. Make sure the strip fits snugly, but not too tight or too loose. Use a pencil to mark the place where the strip or string overlaps.
Step 3: Check the size
To make sure that the determined ring size is correct, you can wrap the thin paper strip or string around your finger again and place the ring on it. Check that it fits comfortably and is not too loose or too tight. Repeat this step if necessary to find the optimal size.
Tip: If you want more accurate measurements, you can repeat the process several times and take the average of the measurements.
Step 4: Compare with our size chart
Now compare the measurement you noted with our size scale and choose the appropriate ring size.
Size | Inner diameter |
1 | 16.5 mm |
2 | 17.3 mm |
3 | 18.1 mm |
Don’t worry too much about your ring size.
After your order you will immediately receive our LIINI fingerprint kit.
Included are original and pre-cut ring templates to try on.
So you can always change to a smaller or larger ring before engraving in the worst case.